The melabs Field Programmer is usually powered by the target board to which it is attached.
However, there may be some cases where the target does not provide power or a device is to
be programmed in a standalone device adapter. In these cases, the melabs Field Programmer
Power Adapter can be used to power the melabs Field Programmer, as well as the target device.
This Adapter is preset for a 5VDC output. Resistors
can be installed to reduce the voltage to
4.6V or 3.5V. This voltage reduction is required when programming
PIC MCUs that can't tolerate a 5V supply.
The jack is center positive with an input voltage of
7.5 - 20VDC.
Copyright 2017 ME Labs, Inc. 2845 Ore Mill Road, STE 4 Colorado Springs CO 80904 (719) 520-5323 (719) 520-1867 fax email: firstname.lastname@example.org
PIC, PICmicro, dsPIC, and MPLAB are registered trademarks of Microchip Technology Inc. in the USA and other countries. PICBASIC, PICBASIC PRO, PICPROTO, and EPIC are trademarks of Microchip Technology Inc. in the USA and other countries. BASIC Stamp is a trademark of Parallax, Inc.